What industries are mixing tanks used for
Structure of mixing tank: The mixing tank consists of a mixing tank body, a mixing tank cover, a mixer, a support, a transmission device, a shaft seal device, etc. Heating or cooling devices can also be configured according to process requirements. Due to different production process requirements of users, the mixer can be configured in various forms such as slurry, anchor, frame, spiral, etc.
transmission
The transmission device of the mixing equipment includes an electric motor, a gearbox, a coupling, bearings, and a frame. The mixing drive mechanism usually adopts a combination of electric motor and gearbox or selects a motor with a frequency converter to achieve the required speed of mixing.
The function of the transmission device is to rotate the mixing shaft at the required speed and ensure that the mixing shaft obtains the required torque. In most mixing equipment, there is only one mixing shaft, and the mixer rotates in one direction at a constant speed. However, there are also some special mixing devices that can use two mixing shafts in one mixing device to achieve better mixing results, and allow the mixer to perform complex movements such as reciprocating, reciprocating, planetary, etc.
Introduction to Liquid Mixing Tank:
1. Equipment material: SUS304 stainless steel, SUS316L stainless steel, etc.
2. Mixing forms: paddle type, anchor paddle type, frame type, spiral belt type, turbine type, dispersed disc type, combination type, etc.
3. Heating method: electric heating, steam heating, water bath heating.
4. Heat transfer medium: heat transfer oil, steam, hot water, electric heating.
5. Heat transfer structure: jacket type, outer coil tube type, inner coil tube type.
6. Equipment structure: upper and lower flat bottoms, upper and lower slants, upper and lower cones, upper and lower heads, etc.
7. The mixing tank can be customized to process 100L-5000L according to customer process requirements.
Characteristics of mixing tank:
1: Suitable for stirring, mixing, blending, and homogenizing powders and liquids, or liquids and liquids;
2: Design the structure and configuration according to the customer's production process requirements; More standardized and humanized;
3: During the mixing process, it can achieve feed control, discharge control, mixing control, and other manual and automatic controls;
4: Can be purchased separately or in sets according to the actual situation of the customer;
Mechanical seal is a device that changes the sealing surface of the shaft from axial to radial, and achieves sealing by the mutual contact and relative movement of the two end faces of the moving ring and the stationary ring, also known as end face seal. Mechanical seals have low leakage rates, reliable sealing performance, low power consumption, long service life, no need for frequent maintenance, and can meet the sealing requirements of production process automation, high temperature, low temperature, high pressure, high vacuum, high speed, as well as various flammable, explosive, corrosive, abrasive media and media containing solid particles.
